Crystal Bond Diy Kit – Clear epoxy resin DIY kit
Features
Self-levelling
Solvent-free
Excellent adhesion
Perfectly clear
High hardness
Surfaces
Wood
Metal
Stone
Ceramics
Porcelain
Cardboard
Technical Data
Coverage
Thinning
Touch Dry
Recoat Time
• Remove any silicone and oils that may be present on the metal using nitro thinner or epoxy thinner.
• Clean and dry the application surface thoroughly.
• Sand the surface well with sandpaper.
• Apply the epoxy primer in one or two coats, according to the instructions of the specific product.
• Mix component A with component B using a low-speed mixer for 2-3 minutes. Then leave the mixture for 30 seconds and mix again for a further 1 minute.
• Important! The full quantity of component A must be mixed with component B in the ratio provided for each set. If a smaller quantity of final product is required, the components must be weighed in the same ratio by weight.
• Also ensure that the final material (A+B) does not remain in the container for more than 50 minutes without being used, as the material will begin to set and will no longer be workable.
• Apply the product in one or two coats. For better workability, it may be diluted with 5-10% nitro thinner or epoxy thinner. The next coat should be applied after the previous one has dried, always after testing.
• Important: at temperatures above 35°C, product adhesion may be reduced.
