PU Antigraffiti 2K – 2K polyurethane anti-graffiti coating
ANTIGRAFFITI TWO-COMPONENT is a two-component, polyurethane-based topcoat designed to provide permanent protection for all building surfaces against graffiti and airborne urban pollutants.
It forms a film with excellent chemical and mechanical resistance, protecting the substrate while providing an outstanding aesthetic finish. It can be applied to both interior and exterior surfaces without affecting their appearance or altering their colour over time. Once the graffiti has been removed with a suitable solvent, there is no need to reapply the coating.
Application tools
Packaging
Features
Permanent graffiti protection
Two-component polyurethane
High chemical and mechanical resistance
High coverage
Surfaces
Concrete
Concrete
Metal
Stone
Marble
Granite
Wood
Technical Data
Coverage
Thinning
Touch Dry
Recoat Time
• Apply on dry, clean surfaces, free from materials that may prevent adhesion.
• Successful application depends on proper substrate preparation and correct application of the material.
• Mix component A with component B using a low-speed mixer for 2-3 minutes. Then leave the mixture for 30 seconds and mix again for a further 1 minute.
• Important! The full quantity of component A must be mixed with component B in the ratio provided for each set. If a smaller quantity of final product is required, the components must be weighed in the same ratio by weight.
• Also ensure that the final material (A+B) does not remain in the container for more than 50 minutes without being used, as the material will begin to set and will no longer be workable.
• Then apply the material to the surface with a roller or brush in one or two coats.
• To adjust viscosity, it may be diluted with 5% nitro thinner or polyurethane thinner.
During application, keep tools “wet” inside the container or paint tray. Drain the paint thoroughly from the tools back into the tin and clean them with nitro thinner or polyurethane thinner.
