Aluminium Epoxy 2K
Special paint with excellent anti-corrosive protection, thanks to the natural aluminium it contains.
Εργαλεία εφαρμογής
Συσκευασία
Χαρακτηριστικά
High adhesion
Excellent protection for metal surfaces
High chemical and mechanical resistance
High coverage
Easy application
Επιφάνεια
Metal Structures
Metal Frames
Industrial Buildings
Metal Stairs
Τεχνικά στοιχεία
Απόδοση
Αραίωση
Επιφανειακό στέγνωμα
Χρόνος Επαναβαφής
• Remove any silicone and oils that may be present on the metal using nitro or epoxy thinner.
• Clean and dry the application surface thoroughly. Sand the surface well with sandpaper.
• Apply in two coats according to the instructions of the specific product.
• Mix component A with component B using a low-speed mixer for 2-3 minutes. Then leave the mixture for 30 seconds and mix again for a further 1 minute.
• Important! The full quantity of component A must be mixed with component B in the ratio provided for each set. If a smaller quantity of final product is required, the components must be weighed in the same ratio by weight.
• Also ensure that the final material (A+B) does not remain in the container for more than 50 minutes without being used, as the material will begin to set and will no longer be workable.
• Apply the product in one or two coats. For better workability, it may be diluted with 5-10% nitro or epoxy thinner. The next coat should be applied after the previous one has dried, always after testing.
Important: At temperatures above 35°C, product adhesion may be reduced.
