Super Floor Epoxy – 2K epoxy floor paint
Solvent-free, two-component epoxy coating with high hardness and excellent resistance to abrasion and chemicals, such as acids, alkalis, oils and grease.
It creates a coloured, seamless final surface that is easy to clean.
Ideal for floors in factories, workshops, department stores, warehouses, garages, repair shops and, in general, floors where high mechanical and chemical resistance is required.
Application tools
Packaging
Features
Strong adhesion
Perfect floor protection
Good mechanical and chemical resistance
Easy to spread
Surfaces
Ideal for surfaces of:
Concrete
Stone
Industrial flooring
Forged cement
Stamped concrete
Mosaic flooring
Technical Data
Coverage
Thinning
Touch Dry
Recoat Time
It is applied on dry, clean surfaces free of materials that prevent adhesion.
The moisture of the substrate should not be more than 4% and be protected damp.
The concrete substrate must be stable with sufficient compressive strength > 25 N/mm2 and tensile strength > 1.5 N/mm2.
The substrate must be at least 3°C above the dew point to reduce the risk of condensation or bubbles at the coating finish.
Priming of the surface (if required) with SUPER FLOOR EPOXY PRIMER in one coat (two coats are required in cases of substrates with increased porosity).
Cracks and holes are filled with epoxy putty or a mixture of SUPER FLOOR EPOXY PRIMER and quartz sand in a ratio of 1: 3 by weight.
Stir component A with component B with a low speed stirrer for 2-3 minutes. Then leave the mixture for 30sec and then repeat the stirring for another 1 minute.
Caution! The entire amount of A to B component must be stirred in the proportion given in each set. If a smaller amount of final product is to be applied then weighing the ingredients in the same weight ratio is required.
Care should also be taken not to leave the final material (A + B) in the container for more than 2-3 hours without working because the material will start to coagulate and it will be impossible to work afterwards.
Apply SUPER FLOOR EPOXY in two coats controlling the maximum recoating intervals. If the maximum recoating time is exceeded, the surface should be ‘roughened’ to ensure good adhesion.
If you want a non-slip surface, apply quartz sand in half of coating’s drying time.
While working, keep the tools “wet” in the container or in the paint bucket. Drain off the paint well from tools into the container and clean them with Epoxy or Nitro Thinner.
